Model 2025-CP
TV CONTROL BOX
#8. INSULATED
QUICK-DISCONNECT
TERMINALS
CP2025A HARDWARE KIT
1. (1) 2025-CP Control Box
2. (1) Plug-in Transformer
Input: 120 VAC, 60 Hz
Output: 16 VDC, 140 ma
3. (2) Insulated Ring Terminals
4. (2) VB-1000 Voltage Blocks
5. (1) 2-Way Splitter
6. (4) Twist-on Type F-Connectors
7. (4) #6 5/8” Screws
8. (4) Isulated Quick-Disconnect
Terminals
9. (1) 5’ 18 GA Insulated Wire
10. (4) 1” Velcro Strips
WARNING!
To prevent FIRE or SHOCK HAZARD, avoid exposure
of control panel to moisture.
NOTE:
Please read all instructions
before
beginning installation!
#6. TWIST-ON
F-CONNECTOR
#1. 2025-CP
CONTROL BOX
#3. INSULATED RING
TERMINALS
#2. PLUG-IN
TRANSFORMER
#10. VELCRO STRIPS
TOOLS NEEDED
#2 Phillips screwdriver
7/16” wrench
Crimping tool
Medium slot screwdriver
Wire stripper
#9. 18 GA INSULATED WIRE
#7. 5/8” SCREWS
#4. VB-1000 VOLTAGE BLOCK
#5. SP-1002 TWO WAY
SPLITTER
REQUIRED ITEMS NOT INCLUDED
IN THIS KIT
FOR TWO OR MORE TV SET SYSTEMS
•
(1) PS-9381 Power Supply
NOTE: VB-1000 & SP-1002 are Winegard
model numbers.
Pull back braid over jacket.
Make sure no braid touches
center conductor. Figure B.
Screw the F-connector onto
the cable jacket until the cen-
ter conductor extends
1/8” past end of connector.
Figure C.
To install the F-connectors,
strip the ends of the RG-59
cable as shown in Figure A.
(Note the ends of the original
30’ cable have been factory
pre-stripped for convenience.)
Figure A
Figure B
Minimum Bending Radius:
3” for RG-59. Tighter bends
will cause shorts and change impedance.
Pulling Tension:
75 pounds maximum. Leave no tension
on cable after it is installed.
Staples or Clamps:
The use of flat staples with coax ca-
ble is damaging to the cable. Only round headed staples
can be used. Any clamps or securing devices used with
coax should grip the cable evenly about the circumference
without crushing the cable.
Exposure to High Heat:
Maximum temperature limit
is 176° F (80° C). Keep cable away from heating vents,
engine compartments and engine exhaust pipes.
Crushing:
Coax should not be installed in a manner that
would allow it to be crushed. It should not be stuffed or
wedged into areas where the cable could be pinched by
the flexing of the boat hull or cabin
.
Exposure to Moisture:
The cable jacket will withstand
most outdoor environments. However, connections and
splices must be sealed against water entry.
HOW TO INSTALL F-CONNECTORS ON CABLE
for female or extend for male
RECOMMENDATIONS FOR INSTALLING CABLE
Figure C
Printed in U.S.A. © 2010 Shakespeare Company
2451257 Rev.1 8/10
Shakespeare Electronic Products Group
6111 Shakespeare Rd., Columbia, SC 29223
