STEP 4. INSTALL THE EXTERIOR DRIP CAP
4A -
It is critical to place the Drip Cap on top of the
Shield Track as seen in the image.
Begin by making guide marks
1-9/16” above the window.
4B -
Secure the drip cap on the right side with 1 pan
head screw. Then, make sure the drip cap is level and
rests on the marks. If so, secure with another pan head
screw.
Use 5 evenly spaced pan head screws to finish securing
the Drip Cap.
STEP 5. INSTALL THE INTERIOR DRAW
CORD LOCK
5A -
Pull the shield up and down a few times to center
the cord in the window.
Once you’ve found the center, let the shield down.
Then measure 14” down from the center and mark
the position.
5B -
Position the bracket over the mark, and place
the tube in a vertical position. The notch should be
at the bottom. Secure the Speed Cinch® with two
#8 x 1”screws. Run cord through the tube.
STEP 6. INSTALL THE INTERIOR GLASS
AND TRACK
6A -
Slide the plastic glass tracks onto each side
of glass panel.
6B -
Hold the glass and tracks over the window
opening, making sure it is even on both sides. Hold
top of glass about ¾” above the top of the window
opening.
6C -
Using washer head screws, secure one track
on the right side of the window (top and bottom).
On the left side of the window, place one washer
head screw in the top hole of the opposite track.
Lower the glass to ensure the glass is level and
will slide smoothly. Secure the bottom of track
with a washer head screw. Place the third screw
in middle of both tracks.
11/2018
Gun Window - Silent Shadow Window System
SUMMIT OUTDOORS, LLC
Fort Wayne, IN 46804 • Toll Free: 1-888-446-4868 Fax: 260-483-2070
www.shadowhunterblinds.com
14” down
from the center
5C -
Run the cord through the speed cinch tube. Then
thread the cord throught the rubber shield stop. Now
tie a knot at the end of the cord. You may need to
adjust the knot to make sure the shield is at or just
below the window.
