16
|
| ASSEMBLY
Assemble the roller tube (see ref. 20 fig. 19),
including the fabric, previously rolled up, into
the newly fixed roller support and fit the sec-
ond roller support onto the square bar like the
previous one.
ATTENTION
To remove the roller support from the square
bar: 1) slacken the support screw but do not
remove it. 2) strike the head of the screw with
a rubber hammer to release the fixing wedge
from the square bar. If necessary, repeat the
operation from point 1). 3) slip the support
off the square bar. Use the rubber hammer if
necessary, gently striking the lower part of the
support.
If provided, assemble the compensator sup-
port (see ref. 21 fig. 20) (see tab. 4).
fig.20
fig.19
fig.21
If the arm holder is to be used (see ref. 22 fig.
21), proceed as follows:
insert the arm holder in the groove in the ter-
minal bar (with the aid of a rubber hammer);
assemble the terminal bar, inserting the fab-
ric in the ogive (see ref. 23 fig. 23) insert the
plate of the terminal bar connecting kit and
lightly tighten the screws.
fig.17
fig.18
Fit the roller support on the square bar (see
fig. 17), (side opposite the control). Check that
the support is right against the square bar.
Tighten the screw TCCE M8 (Allen wrench 6).
ATTENTION
Do not use the screwdriver.
1
2
3
20
21
22
