ShadeLab STILLA, Assembly Manual

Page: 15 / 24

| ASSEMBLY |
15
If the arm holder is to be used (see ref. 20 fig.
19), proceed as follows:
insert the arm holders in the groove in the ter-
minal bar with the aid of a rubber hammer);
insert the plate of the terminal bar connecting
kit and lightly tighten the screws.
Push the arms towards the supports, centre
the terminal bar with the fabric; once this has
been checked, the terminal bar connector
screws can be tightened (Allen wrench 5).
ATTENTION
Ensure that the terminal bar is firmly fixed
to the arms to prevent their opening without
control.
fig.20
fig.19
fig.21
Insert the terminal bar caps (see ref. 21 fig.
21).
fig.17
fig.18
Assemble the insert including the motor
plate/crank (see ref. 19 fig. 17) on the roller
tube on the control side.
Assemble the tube complete with fabric, ter-
minal bar and inserts on the arm supports,
tightening the screws (Allen wrench 5) (see
fig. 18).
ATTENTION
Do not use the screwdriver. Ensure that the
inserts are firmly fixed to the supports.
19
20
21