PAGE 5
1. The jack handle should be placed
on the release valve and turned anti-
clockwise to open the valve.
2. Place the handle back into the
receiver and pump the jack handle up
and down 20 times.
This should force any air from the
system and lubricate the seals.
3. Close the release valve by turning
clockwise.
4. Test the jack. If the jack won’t lift, or
lifts but won’t hold a load, then repeat
the procedure. If the problem persists
then please contact us.
PURGING YOUR TROLLEY JACK
Sometimes during transport and handling, air gets into the
hydraulic system causing poor lifting performance. Before the
initial operation purge any air from the system by following
these steps:
Summary of Contents for TJ2
Page 11: ...PAGE 11 TECHNICAL DIAGRAM...