SGS SDG8000SELR Owner'S Manual Download Page 5

PAGE 9

PAGE 8

FILLING WITH ENGINE OIL

When checking the oil level make sure your engine is sitting level. If it is 
tilted, you may add either too much or too little oil. If you over fill, your 
engine will consume too much oil and the oil temperature will become dan-
gerously high; if you do not add enough oil, your engine could seize up.

When checking the oil, simply dip the 
dipstick into the oil pan. Do not screw in 
the dipstick.

Be sure to check the engine on a level 
surface with the engine stopped.

Replacing engine oil

After engine has been run prior to changing the oil will be very hot. Wear 
the correct PPE - a minimum of gloves and overalls.
 
1.  DO NOT allow any dust, dirt or any other debris to enter oil or crank-

case.

2.  Remove the oil fillercap.
3.  Remove the drain plug and drain the old oil while the engine is still-

warm.

4.  The plug is located on the bottom of the cylinder block.
5.  After draining, re-tighten the drain plug and refill with the recommend-

ed oil API CH-4/CF/SJ/SL diesel engine oil or higher grade.

BATTERY

When you first install the battery, ensure that the battery’s polarity is the 
same as the generator’s battery leads:

 

Black = negative

 

Red = positive.

1.  Using a voltmeter- check the voltage is 12.3V+, if lower, the battery 

must be charged.

2.  Check that the voltage is correct every month. The battery should be 

between 12.5v and 13.6v. When the engine is running it should re-
charge the battery.

3.  Make sure battery is free from damage and is not leaking. If battery 

shows signs of damage or leaking – DO NOT continue to use. Instead 
replace battery immediately.

4.  Make sure that all battery acid spills are correctly cleaned up straight 

away.

5.  The battery should be stored in a charged condition.
6.  The battery is a 12 volt 36Ah sealed lead acid battery and requires no 

maintenance other than;

•  Ensure battery terminals are kept clean, tight and covered to prevent 

shortcircuiting.

•  If the battery voltage is too low, it will require charging before use.
•  Keep the battery in a cool, dry place. It is important to clean the bat-

tery every three months and charge every six months.

WWW.SGS-ENGINEERING.COM

Summary of Contents for SDG8000SELR











Reviews: