PAGE 15
PAGE 14
1. Disconnect power source then release all pressure from the system be-
fore attempting to install, service, relocate or perform any maintenance.
2. Never unscrew any connecting part when the tank is pressurised.
3. Never disassemble any electrical part before disconnecting the plug.
4. Never adjust the safety valve carelessly.
5. Never use the compressor where voltage is too low or too high.
6. Never disconnect the plug to stop the compressor, set the switch knob
to the off position instead.
7. Lubricating oil must be clean and at the level indicated.
8. Clean crankcase and renew lubricating oil after the first 10 working
hours. Check the oil level after every 20 working hours, and replenish if
necessary.
CAUTIONS
MAINTENANCE
CLEAN THE AIR FILTERS (MONTHLY)
The air filters must be examined monthly and
more often in dusty conditions:
1. Unscrew the filters from the compressor.
2. Remove the filter covers from the filters.
3. Clean the sponge and the filter cover
using a soft brush. If necessary, the filters
can be carefully cleaned in warm soapy
water. Rinse and let the filters dry com-
pletely before refitting.
4. Make sure that the filters and filter cov-
ers are replaced into position. If the
filters are damaged, you must replace
them.
CLEANING
1. Open drain cock under the tank to ex-
haust condensate after every use.
2. Clean the crankcase and renew the oil,
clean air filter, and check safety valve and
pressure gauge after every 120 working
hours.
WWW.SGS-ENGINEERING.COM
