PAGE 15
PAGE 14
1. Disconnect power source then release all pressure from the sys-
tem before attempting to install, service, relocate or perform any
maintenance.
2. Check compressor often for any visible problems and follow
maintenance procedures each time compressor is used.
3. Pull ring on safety valve and allow it to snap back to normal posi-
tion. Safety valve must be replaced if it cannot be actuated or it
leaks air after ring is released.
4. Turn compressor off and release pressure from system. Drain
moisture from tank by opening drain cock underneath tank.
5. Clean dust and dirt from motor, tank, and airlines and pump
cooling fins while compressor is still OFF.
6. IMPORTANT: Locate unit as far from spraying area, as hose will
allow preventing overspray from clogging filter.
7. Unclip the air filter cover, remove the filter and blow away any
loose dirt. If damaged or badly contaminated, it must be re-
placed.
8. Clean the fins of the compressor cylinder and the cylinder head
to receiver pipe. A clean compressor will work more efficiently.
9. LUBRICATION This is an oilless type compressor requiring no
lubrication.
MAINTENANCE
MAINTENANCE
CLEAN THE AIR FILTERS (MONTHLY)
The air filters must be examined month-
ly, more often in dusty conditions:
1. Remove the filter covers from the
compressor.
2. Remove the filter covers from the
filters.
3. Remove the filters from the filter
covers.
4. Clean the sponge and both the
filters cover using a soft brush.If
necessary, the filters can be care-
fully cleaned in warm soapy water.
Rinse and let the filters dry com-
pletely before refitting.
5. Make sure that the filters and filter
covers are replaced into position. If
the filters are damaged, you must
replace them.
WWW.SGS-ENGINEERING.COM
