SGS Household Oxygen Bar, Operating Instructions Manual

Page: 8 / 10

10
Problem Investigation and Trouble Shooting
Symptom
Possible Cause Solution
Household oxygen
bar cannot operate
properly, the power
indicator light is not
bright.
The power line is not conne-
cted to a power outlet.
Power supply socket without
electricity.
Overload protection burning fuse
Power cord is not for good in
the household oxygen bar or
power cord bad.
Check whether the socket outlet connection
is normal.
Replace the electric socket.
Open the insurance and replace the fuse.
Unplug reinsert the fuselage outlet or repl-
ace a power supply cord.
The screen display
normal, but the oxy-
gen bar does not ha-
ve normal operation
soun.
Household oxygen bar over-
heating protection.
Household oxygen bar com-
puter froze plate.
The compressor function b-
reakdown.
Make sure the place has been away from ho-
usehold oxygen bar curtains, bake warm m-
achines, heaters and fireplaces, and confirm
household oxygen bar and walls or other o-
bjects around the retention gap of at least
20 cm.
Turn off the machine, wait five minutes to
restart.
Contact household oxygen bar retailer or m-
anufacturers.
Full screen flash,
while alarm.
Internal hardware damage
Returned to the manufacturer or dealer for
repair.
Big Noise
Ties are not cut, the machine
did not put a smooth.
Cut ties, put the machine steady.
The screen display
normal and hear n-
ormal operation so-
und but no anoin o-
xygen output.
Intake window cotton filters
is dirty, cause block. Household oxygen bar internal malfunction.
Cut off the power switch, r-
eplace window air intake fi-
lter cotton.
Contact the household seller or manufactu-
rers.
Press to adjust the
time when the tra-
nsfer is invalid.
Sleep tone when keys are lo-
cked, inoperable.
Press the "On / Off" button to wake, the key
to adjust the time and then tune.
09
Problem Investigation and Trouble Shooting
Symptom
Possible Cause Solution
The oxygen machine
emits poof bared s-
ound six-minute int-
ervals.
Water coming out
of the mouth of o-
xygen.
the machine is op-
erating normally -
after starting up,
but have a narrow
minded.
Oxygen odor
The machine emits exhaust
sound.
Adding too much water in the
wet cup
（
exceed the highest
water level
），
airflow will
push oxygen tube blisters.
Difference temperature , ca-
use the humidified oxygen in
the wall that moisture will c-
ondense water out of cold.
Flow value is too small.
Oxygen tube was twisted or
flatten.
Early use, series of tubes or
other plastic will emit odor,
is a normal phenomenon.
If the machine emits poof bared sound reg-
ularly is a normal phenomenon, discharge
the sound of nitrogen.
The water in the wet cup have reduced to the
highest water level.
Pour the water out of the wet cup, starting
up, after fifteen minutes ,waiting the dropl-
ets are dried in the oxygen tube, then adding
water into the wet cup.
Turn up flow
1. Tank silicone stopper loose, remove the
tank and the silica gel plug impaction.
2. The tank did not put into the machine in
place, should be put into the tank with a lit-
tle push.
3. The gas tank has two aprons in and out of
the mouth, if not installed well, it can lead
to leakage.
This odor is normal smell emitted by the sil-
icone tube, which has been detected by non
toxic, and with the use of the machine, the
smell will gradually disappear.