2. Connect the machine to power supply, turn the “power switch” on, as shown in Figure 1. (Rated voltage:
V, rated power:
W)
Ⅰ
. Commissioning
Figure 1
Figure 2
01
Heating plate
Adjustment hand wheel
Mould base
Figure 3
Celsius degree indicator
Setup indicator
Time indicator
Temperature
display
Time display
-
+
Power switch
1. Remove the package and cable ties, lift the pressure handle, as shown in Figure 1. Rotate the “adjustment hand
wheel” to an appropriate position of pressure, as shown in Figure 2.
Mould
Pressure handle
-
+
Fahrenheit degree indicator
Temperature setting
Time setting
3.Parameter settings
a. When the display is powered on, there will be a short beep and letter “K” will be displayed on the upper display window while the set value of temperature is
displayed on the lower display window. Then, the measured value of temperature and the set value of time will be displayed on the upper and lower windows.
b. Fahrenheit degree selection: as shown in Figure 3, the “Fahrenheit degree indicator” indicates whether the temperature is displayed in Fahrenheit degree.
Since there are a variety of ways to switching between Fahrenheit degree and Celsius degree, specific switching methods are not introduced in this user
manual. If there is any need for temperature unit swathing, please contact the distributor or the manufacturer or use the formula below: [Fahrenheit
degree= 32 + Celsius degree
×
1.8; Celsius degree= (Fahrenheit degree - 32)
÷
1.8)
Figure 4