TB 220
TM
Turf Brush Owner’s Manual Rev D
Copyright 2015 SGM Industries, LLC
Page 9 of 11
Maintenance
The TB 220
TM
Turf Brush was designed to be a low maintenance product. Please follow
the service procedures outlined below to keep your brush running in top condition.
Check the tire pressure regularly and keep them inflated to 14 psi (97 kPa).
The chain cover (35) should be removed periodically and checked for any build-
up of debris. Clean this out as needed. While the cover is removed, check the
chain (34) tension. There should be a sag in the top chain of ½” to 1”. Adjust the
tensioner shaft weldment (42) as necessary. The chain should also be lightly
coated with a dry silicone spray. Reinstall the cover. Never operate the unit
with the chain covers removed.
Watch for loose hardware, pins, or fasteners. Tighten as necessary.
The TB 220
TM
Turf Brush should be washed as needed using soap and water to
remove any debris or dirt.
The drive tire bearings (14) should be checked on an annual basis and re-packed
with a quality wheel bearing grease if necessary.
The electrical system is protected by a 25 amp mini ATM automotive fuse,
located just ahead of the red battery clip.
Repair parts are readily available from the factory.
