20
Height
530 mm
Connection cable
REMOVING THE FRONT RING
1.
Turn the fixture off, disconnect it from mains and allow it to cool.
2.
Place the fixture on a flat, level surface, with the front facing up, and activate the tilt lock.
3.
Loose up the 8 screws behind the front ring to remove it (figure 14).
4.
Place the front ring, with the lens facing down, over the elevated flat, clean and scratch-free surface. Notice that the
electrical wire connecting the light source to the head is short and located left of the tilt lock (figure 15). Avoid touching the
reflector, and cover it with a dust-free cloth.
5.
To release the front ring from the head, remove the small plate surrounding the front ring's cable (figure 16) by loosening the
2 screws, and disconnect the two wires by pressing the connectors' clip.
Figure 14
Figure 16
Figure 15
Tilt Lock
Gobo replacement
WARNING! Handle components with care. Always wear suitable gloves.
Every time the front is opened, the thermal pads have to be replaced. (item number
21400060 )
BEFORE STARTING
•
Be sure the fixture is in a clean, dust free, and dry environment before opening it.
•
The internal thermal pads must be replaced when servicing the unit. Be sure extra thermal pads are available before
opening the fixture.
•
Prepare a dust free cloth to protect the reflectors when removed.
•
Make sure an elevated, flat, and clean surface, or riser, is placed close to the front ring, so the front can rest over it while
accessing the internal parts.
•
Don't touch the reflectors, the colour filters, or the gobos, even while wearing gloves. This may cause permanent damage.
•
Use only borosilicate glass gobos with 27.9 +0/-0.2 mm or 27.8 ±0.1 mm diameter size.
Note: assembly
torque for the
front ring is
1Nm
TX 20
TX 20
