11
Setting a static color manually
The P-6 can be configured to display a predefined and static color.
To set up a static color, select ENTER → MANUAL → QUICK COLOR.
Note that once the MANUAL → QUICK COLOR settings are changed, the fixture will, by default, be set to automatically start in quick
color mode whenever it is powered on. This can be reset through the menu SETTINGS → STARTUP MODE → SELECT STARTUP
MODE.
The current quick color program can always be stopped going to:
ENTER → MANUAL → STOP PROGRAM
See “Control menu” on page 13 for detailed information.
Factory default
When restoring factory defaults in the P-6, the following settings will be set:
• DMX address = 1
• DMX mode = Default mode (6 channel)
• Startup mode = DMX
• Display saver = Off
• Flip screen = Off
• RDM device label set to = Fixture type name
• Internal program reset
Effects
The P-6 is a luminaire with 24 high-power RGBW 24W LEDs, divided in 6 individually controllable segments, which generates
wide-ranging color effects and pixel-mapping combinations for creative lighting designs.
Individual fixture settings
Flipping the OLED display
If the fixture is installed hanging upside down, it might be useful to flip the display so that it is easier to read.
To flip the display, press ENTER and select SETTINGS → FLIP DISPLAY, or press the up and down buttons on the control panel at
the same time.
Setting the OLED display saver
By default the OLED display dims down after a short period when the control panel is not in use. The display can also be set to turn off
completely, ideal when a pitch-black environment is required. Pressing any key will always turn on the display or restore it to normal
brightness.
To configure the display settings, press ENTER → SETTINGS → DISPLAY SAVER.
NOTE: To avoid the risk of display deterioration caused by long term use, it is recommended to select the setting → DISPLAY OFF.
Setting the fan mode
For operating environments where low-noise is a requirement, or where the fixture will be operating in high temperatures, it is possible
to adjust the default fan speed by going to SETTINGS → FAN MODE in the menu.
Fixture properties
Figure 11: P-6 Pixel segments
Pixel 1
Pixel 3
Pixel 5
Pixel 2
Pixel 4
Pixel 6
