
Strato Pi CAN server
The Strato Pi CAN server comes pre-assembled with a Raspberry Pi 3 Model B or B+
board, in a plastic standard DIN-rail case.
There is no need to open the case, unless a change in the CAN or RS-485 termination
resistors is required (see below).
The Micro SD card (not provided) can be inserted through a small opening on the side of
the case. Use a small pen or paper clip to gently push the card in its slot.
Replacing the RTC backup battery
Strato Pi CAN has a hardware real time clock with a dedicated long-life non-rechargeable
back-up battery.
Strato Pi CAN is shipped with a
CR1220VCN
Lithium / Manganese Dioxide (Li/MnO2)
battery soldered to the circuit board.
The battery is only used to power the RTC chip when the main power is not available
(when the Raspberry Pi is off). Depending on operating conditions it should last up to three
years if the Strato Pi board is not powered, more if the Strato Pi CAN receives external
power.
Improper handling of lithium batteries can result in an explosion of the batteries and/or
release of harmful substances.
Worn-out or defective batteries can compromise the function of this product.
KEEP OUT OF REACH OF CHILDREN
. Swallowing may lead to serious injury or death in
as little as 2 hours due to chemical burns and potential perforation of the esophagus.
Immediately see doctor.
Replace the RTC lithium battery before it is completely discharged. Replace the battery
every 5 years even if the battery is still working properly. The lithium battery must be
replaced only with an identical
CR1220VCN
Lithium / Manganese Dioxide (Li/MnO2)
battery.
Do not throw lithium batteries into fire, do not solder on the cell body, do not recharge, do
not open, do not short-circuit, do not reverse polarity, do not heat above 100°C and protect
from direct sunlight, moisture and condensation.
Dispose of used batteries according to local regulations and the battery manufacturer's
instructions.
The RTC backup battery is soldered to the circuit board next to the GPIO connector. In the
Strato Pi CAN server, the battery is not accessible from the outside. You should first
remove the case top body to gain access to the Strato Pi CAN circuit board.
WARNING
10
Strato Pi CAN User Guide