FW5870 User's Manual
M4051-01
１４
１４
１４
１４
Seyeon Tech Co., Ltd
3. FW5870 Installation and Basic Setup
3.1. Before Installation
Read carefully User's Manual.
Check User’s Network (IP Address, Network Mask and default gateway)
Secure IP address for FW5870.
3.2. Factory Default Settings
The following table shows the factory default condition. Please refer to this when you need to change the
values on admin menu.
Factory Default
Admin ID
root
Admin password
root
IP address
10.20.30.40
Network mask
255.255.255.0
Gateway
10.20.30.1
Table 5 : Factory Default
Note:
Factory default Admin ID and Password are all lower case letters. You can change the
password with Capital letters.
3.3. Installing FW5870
For installation of FW5870, please follow the steps below.
1.
Place the CCTV cameras in place and connect power supplies.
2.
Connect the video output ports of analog CCTV cameras to the video-in ports of FW5870.
3.
Connect the FW5870 to the Internet cable through the LAN port.
4.
Connect the power supply of FW5870.
After that, you need to follow the steps below.
Network Configuration: Refer to “IP Installer User’s Manual”
Camera Configuration: Refer to “FlexWATCH Admin Menu User’s Manual”
Service Configuration: Refer to “FlexWATCH Admin Menu User’s Manual”
