2
Safety Notes
General information
6
Operating Instructions – MOVIFIT
®
SC
2
Safety Notes
The following basic safety notes must be read carefully to prevent injury to persons and
damage to property. The operator must make sure that the basic safety notes are read
and observed. Make sure that persons responsible for the system and its operation, as
well as persons who work independently on the unit, have read through the operating
instructions carefully and understood them. If you are unclear about any of the informa-
tion in this documentation, or if you require further information, please contact SEW-
EURODRIVE.
2.1
General information
Never install or startup damaged products. In the event of damage, submit a complaint
to the shipping company immediately.
During operation, MOVIFIT
®
SC, depending on the enclosure, may have live, uninsu-
lated, and sometimes moving or rotating parts as well as hot surfaces.
Removing required covers without authorization, faulty use and incorrect installation or
operation may result in severe injuries to persons or damage to property.
Consult the documentation for additional information.
2.2
Target group
Only
qualified personnel
should perform installation, startup, fault repair and servicing
(observe IEC 60364 or CENELEC HD 384 or DIN VDE 0100 and IEC 60664 or DIN VDE
0110 as well as national accident prevention guidelines).
In the context of these basic safety notes, electricians are persons familiar with installa-
tion, assembly, startup, and operation of the product who possess the necessary quali-
fications for their work.
All activity in the other areas of transportation, storage, operation, and waste disposal
must be carried out by persons who are appropriately trained.
2.3
Designated use
MOVIFIT
®
SC is a component intended for installation in electrical systems or
machines.
When installed in machines, startup of the MOVIFIT
®
SC (i.e. start of designated use)
is prohibited until it is determined that the machine meets the requirements stipulated in
EC directive 98/37/EC (Machine directive).
Startup (i.e. the start of designated use) is only permitted in compliance with EMC direc-
tive (89/336/EEC).
MOVIFIT
®
SC meets the requirements stipulated in the low voltage directive
2006/95/EC. The standards contained in the declaration of conformity are used for
MOVIFIT
®
SC.
Technical data and information on the connection requirements are provided on the
nameplate and in the documentation; these must be observed under all circumstances.
Summary of Contents for MOVIFIT SC series
Page 2: ...SEW EURODRIVE Driving the world ...
Page 146: ......