INFLA
TABLE ST
ANDUP P
ADDLEBOARD
5
®
®
All Inflation is done in the LOCKED position and deflation is done in
the OPEN position. When finished inflating, replace the cap to prevent
sand, water and other debris from collecting in the valve cavity.
The recommended inflation pressure is: 10 -12 PSI.
Use only the provided special high pressure pump to properly inflate
the Inflatable. Insert the nozzle at the end of the pump hose and
twist it clockwise. Be sure the pump is set in “Inflating” mode and
start pumping. Periodically check the board pressure. The pressure
can be checked with the provided pressure gauge which measures
up to 30 PSI. See the enclosed pressure gauge instructions for a full
explanation of how to use.
INFLATION
The inflatable is equipped with a rugged high pressure valve. Please
familiarize yourself with it before you start inflating. The valve has
a screw-in cap attached with a Nylon cord. Unscrew the cap and
expose a notched center post. This is where you lock and open the
valve. Pushing down firmly with your thumb, rotate the post counter
clockwise to lock and clockwise to open the valve.
WARNING!
If you leave your product exposed to the hot sun check the pressure;
if the pressure is greater than 12 PSI, deflate it slightly to avoid
overstretching the material.
