7
INSTALLATION
Notes:
Choose the mounting location where
the unit will not interfere with the
normal driving function of the driver.
Before
finally
installing
the
unit,
connect the wiring temporarily and
make sure it is all connected up
properly and the unit and the system
work properly.
Use only the parts included with the
unit to ensure proper installation. The
use of unauthorized parts can cause
malfunctions.
Consult with your nearest dealer if
installation requires the drilling of
holes or other modifications of the
vehicle.
Install the unit where it does not get
in the driver’s way and cannot injure
the passenger if there is a sudden
stop, like an emergency stop.
If installation angel exceeds 30
°
from
horizontal, the unit might not give its
optimum performance.
Avoid installing the unit where it
would be subject to high temperature,
such as from direct sunlight, or from
hot air, from the heater, or where it
would be subject to dust, dirt or
excessive vibration.
DIN FRONT/REAR-MOUNT
This unit be can properly installed either
from “Front”(conventional DIN
Front-mount) or “Rear”(DIN Rear-mount
installation, utilizing threaded screw holes
at the sides of the unit chassis). For
details, refer to the following illustrated
installation methods.
DIN FRONT-MOUNT (Method A)
Installation Opening
This
unit
can
be
installed
in
any
dashboard having an opening as shown
below:
Installing the unit
Be sure you test all connections first, and
then follow these steps to install the unit.
1. Make sure the ignition is turned off,
and then disconnect the cable from
the
vehicle
battery’s
negative
(-)
terminal.
2. Disconnect the wire harness and the
antenna.
3. Lift the top of the outer trim ring then
pull it out to remove it.
4. The two supplied keys release tabs
inside the unit’s sleeve so you can
remove it. One key is for the right side
and the other is for the left side. Insert
the keys as far as they will go (with
the
notches
facing
up)
into
the
appropriate slots at the middle left and
right sides of the unit. Then slide the
sleeve off the back of the unit.
30
53mm
182mm
Outer Trim Ring
L Key
Sleeve
R Key
