14
142 x 208 mm
Storing wine
∙
The following temperatures are suitable for various
wines:
Red:
15 -18 °C
Dry/white:
10 -15 °C
Sparkling/champagne: 5 - 9 °C
∙
The appliance can store up to fourteen 750 ml Bordeaux
bottles:
Top compartment:
5 bottles (max. bottle height
31 cm)
Middle compartment: 5 bottles (max. bottle height
31 cm)
Bottom compartment: 2 x 2 bottles on top of each other
(max. bottle height 35 cm)
∙
When there are no bottles on the wooden shelves, pull
them out with little force but carefully. The pull-outs
move easily when the wooden shelves are not loaded.
Cleaning and care
∙ Always remove the plug from the wall socket before
cleaning.
∙
The cabinet should be cleaned once a month.
∙
During operation, you may notice a build-up of frost
around the integral evaporator sealed into the rear of
the inside cabinet. This layer of frost will start melting
when the compressor is not working. Through a system
of hoses, the melt-water drains into the collection tray
below the compressor, where it will be absorbed into the
surrounding air. Therefore, the appliance requires no
defrosting and should only be cleaned.
∙
To enable the melt-water to drain freely, always ensure
that the discharge opening on the rear interior wall of the
cabinet is free of any blockage.
∙
Any water collecting in the bottom should be removed.
∙
Do not use abrasive tools, materials containing alcohol
or harsh cleaning solutions.
∙
Do not use any electrical appliances, such as steam
cleaners, for de-frosting or cleaning.
∙
Do not pour water over or inside the unit.
∙
For frequent cleaning we recommend the use of a damp
cloth and a little mild detergent.
∙
Use a slightly damp cloth to clean the wooden shelves.
∙
After cleaning, all surfaces must be wiped completely
dry. When re-inserting the plug into the wall socket
ensure that you have
dry hands
.
Trouble-shooting
Certain typical sounds can be heard when the appliance is
switched on. These sounds are caused by:
∙
the electric motor within the compressor assembly;
during compressor start-up the sound level will be
slightly higher for a short time.
∙ the cooling agent flowing through the circuit.
∙
In addition, the side of the housing may become warm.
This heat is caused by dissipation of the heat generated
inside the cabinet.
∙
The following table lists possible malfunctions,
their probable causes and solutions. In the event of
operational problems, check first whether a solution
can be found using this table. If the problem persists,
disconnect the appliance from the mains power and
contact our Customer Service Department.
Summary of Contents for WKS 8892
