SEVERIN SM 9681, Instructions For Use Manual

Page: 12 / 80

12
been dropped onto a hard surface, or if
excessive force has been used to pull the
power cord, it must no longer be used:
even invisible damage may have adverse
effects on the operational safety of the
appliance.
∙ This appliance is solely designed for
heating up and frothing milk. Do not put
any other type of liquid or solid food in
the container.
∙ Do not leave the milk frother unattended
while in use.
∙ Always observe the maximum level
marks inside the container for each
application. If there is not enough milk,
the appliance may overheat.
∙ To prevent such overheating, the
appliance will automatically switch off if
it is operated when empty. If this occurs,
the indicator light will go out. Remove
the plug from the socket and allow the
appliance to cool down.
∙ Over fi lling the container may cause
danger if frothing milk is forced out.
∙ Caution: The lid must always be fi tted
during operation; it should only be taken
off to add cocoa powder or the like.
∙ The appliance may only be used with the
original accessory parts provided by the
manufacturer.
∙ The appliance must always be set on a
fi rm, level surface.
∙ Do not allow the appliance or its power
cord to come into contact with open
fl ames or any hot surfaces such as hot-
plates.
∙ Do not allow the power cord to hang free;
the cord must be kept well away from hot
parts of the appliance.
∙ Always remove the plug from the wall
socket
- in case of any malfunction,
- after use,
- before cleaning the appliance.
∙ When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
∙ No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
Before using for the fi rst time
Remove any packaging materials and check
that all components are present.
Before the appliance is used for the fi rst
time, or after extended periods of non-use, it
should be thoroughly cleaned as described
in the section Cleaning and care .
Operation
∙ We recommend using milk with a high
protein content. For best results, the
milk should be taken from the refrigerator
immediately before frothing.
∙ Always ensure that the contact surface
between the base and the milk container
is clean and dry.
Selecting the stirring insert
∙ To froth milk, fi t the stirring insert with the
coil onto the shaft of the holder, with the
fl at side facing downwards.
∙ Simply to heat milk, fi t the stirring insert,
without the coil, onto the holder shaft,
with the fl at side facing downwards.
∙ The rubber ring must be fi tted on the
holder during operation. Do not use the
appliance without the rubber ring.