–
Fit the covering panel (provided) below the freezer compartment
door.
–
Fit the two spacer elements (1), provided, into the corresponding
guide slots (2) on the rear.
–
Before it is connected to the mains, the unit must be thoroughly checked for transport damage,
including its power cord.
–
Clean the unit as described in the section
De-frosting and cleaning
.
–
For positioning, we recommend that you tilt the unit slightly backwards. In this way, the
transport rollers can be used to move it to its intended place of installation.
–
The unit should only be transported in its vertical position; do not tilt any more than 30°.
–
Once the unit has been positioned, wait for about 30 minutes before it is connected to the mains.
–
If the unit has been tilted more than 30° during transport, allow it to stand upright for at least 4
hours before it is connected to the mains.
–
When the unit is first switched on, a slight 'new' smell may be noticed. However, this will
disappear once the cooling process has begun.
Installation
The appliance should be set up in a well-ventilated, dry room.
It should be operated in conditions where the relative humidity is no more than 70 %.
The product data sheet at the end of this manual contains details of the ambient temperature
range suitable for this appliance.
Do not use the appliance outdoors.
Ensure that the plug is accessible and can be removed from the wall socket at any time.
Do not expose the appliance to direct sunlight, and do not position it next to any heat sources
(radiators, cookers etc). If this cannot be avoided, however, suitable insulation must be in installed
between the heat source and the unit.
The unit must not be installed inside a cabinet, nor directly below a hanging cupboard, shelf or
similar object.
In the case of uneven floors, the adjustable feet on the unit can be used to compensate and ensure
optimum stability.
18
