SEVERIN KM 3885, Instructions For Use Manual

Page: 10 / 62

out by qualified personnel, including the
replacement of the power cord. If
repairs are needed, please send the
appliance to one of our customer service
departments. The address can be found
in the appendix to this manual.
Operation
Control switch
The control switch allows for the following
settings:
II The unit is switched on - high speed
I The unit is switched on - low speed
0 The unit is switched off
P The unit remains running at high speed
as long as the pulse switch is held at the
P -position.
General information
Before using the unit for the first time, all
attachments and accessory parts must be
cleaned as described in the section
General
care and cleaning .
Always fit the required attachment first
before use.
Note : This kitchen appliance is equipped
with two safety switches. The appliance can
only be switched on if the selected
attachments are correctly fitted and locked.
Turn off the unit after use and wait until the
motor has come to a complete standstill
before changing or removing any
attachments.
A. Chopping/mincing and stirring/mixing
- Attach the bowl.
- Place the drive shaft extension firmly on
the drive shaft in such a way that the
extension almost touches the bottom of
the bowl.
- Fit the chopping/mincing blade over the
shaft extension and push it firmly down
as far as it will go.
Caution : Hold the blade only by its
fitted plastic grips - the blades are
extremely sharp.
- Put the ingredients (max. 500g) into the
bowl.
- Place the lid on the bowl and turn it
clockwise to lock ( ). Afterwards
turn the bowl clockwise to lock it ( ).
- Place the small safety lid on the blender
mounting. Ensure that the recess on the
small safety lid is properly fitted over
the corresponding protrusion on the
main lid of the bowl before turning it
clockwise to lock it.
- For safety reasons, use the pestle at all
times when feeding the ingredients into
the food chute. During operation, the
pestle should remain inserted.
Operation settings
a) Chopping/mincing
- With this function, only the Pulse setting
( P) should be used. The desired degree
of chopping/mincing (from coarse to
fine) for meat, onions, dried fruit,
celery, fish etc. is normally achieved
after approx. 15-30 seconds.
b) Stirring/mixing
- The bowl can be filled to a maximum of
1 litre with cold liquid (e.g. soup).
Always start processing at speed level
I .
If necessary, the process may be
repeated at speed level
II .
B. Kneading
- Attach the bowl.
- Place the drive shaft extension firmly on
the drive shaft in such a way that the
extension almost touches the bottom of
the bowl.
- Fit the kneading insert over the shaft
extension and push it firmly down as far
as it will go.
- Put the ingredients (max. 500g) into the
bowl.
- Place the lid on the bowl and turn it
clockwise to lock ( ). Afterwards
turn the bowl clockwise to lock it ( ).
- Place the small safety lid on the blender
mounting. Ensure that the recess on the
small safety lid is properly fitted over
the corresponding protrusion on the
main lid of the bowl before turning it
clockwise to lock it.
10