SEVERIN HS 7834, Instructions For Use Manual

Page: 8 / 46

Should you experience a considerable
decrease in trimming performance, switch
off the appliance and recharge the battery.
- Fit the connecting plug into the
corresponding jack on the charging base.
- Insert the adapter into a suitable wall
socket.
- Ensure that the appliance is switched off
and place it in the charging base. The
mains-power indicator light shows green.
- The charging process begins
automatically. The mains-power
indicator light stays on as long as the
appliance remains in the charging base
with the base connected to the mains
power.
- Whilst charging, the transformer within
the adapter will become warm. This is
perfectly normal and safe and does not
indicate a malfunction of any kind.
- If the appliance has not been used for a
long period of time, the capacity of the
battery may decrease by a certain
amount. However, full capacity will be
restored after several
charging/discharging cycles. Every three
months or so, the appliance should be
completely discharged.
Use
General
The appliance is designed for dry as well as
wet shaving of body areas below the
neckline.
Shaving
- Remove the push-on comb if necessary.
- Use the On/Off switch to turn the
appliance on.
- Place the shaving head on the skin.
- Using only light pressure, move the
appliance over the skin against the
natural growth of the hair, while keeping
the skin tight. For best results, the
shaving head should have maximum
contact with the skin.
Trimming longer hair
- Fit one of the push-on combs on the
shaving head.
- Use the On/Off switch to turn the
appliance on.
- Place the comb with the shaving head on
the skin.
- Move the appliance against the natural
growth of the hair with the tips of the
comb leading.
Push-on combs
The combs allow for adjusting the cutting
lengths in two stages. The smaller comb
increases the cutting length by 2mm, the
larger one by 4mm.
To fit the comb, place it over one side of the
shaving head and then push it down until it
locks into place. To remove the comb after
use, push one of the two side catches away
from the main unit.
Cleaning and care
●
Before cleaning, remove the plug from
the wall socket and switch the shaver off.
●
To avoid the risk of electric shock, do not
clean the appliance with water and do
not immerse it in water.
●
Do not use abrasives or harsh cleaning
solutions.
- The shaving head can be taken off for
cleaning by gently pushing it off the main
unit by its blades. The head may be
cleaned with a suitable brush or under
running water, but without the use of
detergent.
- The charging base and the main housing
may be cleaned with a slightly damp
cloth.
Disposal of the battery pack
●
This appliance contains a nickel-
cadmium (Ni-Cd) rechargeable battery
pack, which cannot be removed. It must
be disposed of together with the
appliance.
8