2
Thank you for selecting a Séura Lighted Mirror.
Please read this guide before beginning installation.
Carefully remove and inspect the unit for possible damage that
occurred during shipping. If there is damage, please call Séura at
1-800-957-3872. If your shipment is damaged and is not noted
on the delivery receipt, Séura cannot guarantee compensation.
All freight damage claims must be reported to Séura Customer
Service within 24 hours of delivery to be covered by our
warranty.
How to properly remove the unit from the box
Carefully lift each item out of the box. Lift the mirror by the
brackets attached to the back of the mirror glass. If the mirror
has a frame, do not pull the unit out of the box by the frame
as the frame may detach from the mirror. Lay the mirror glass
flat or upright against a sturdy wall with the foam protectors
remaining on the unit.
How to properly store the unit until installation
After inspection, repack the unit so it stays safe and protected
until installation.
NOTE:
All Séura drawing packages indicate generalized nominal
residential wood framing construction and are not indicative of
any particular building code. It is the installers responsibility
that all electrical, audio/visual, and framing construction are
code compliant to the municipality in which the product is being
installed. Modifications made to Séura recommendations are
at the sole discretion of the installer and release Séura of all
liability.
Séura Lighted Mirrors use LEDs that are rated to retain 70%
overall brightness and the end of life, including cases where an
individual LED fails.
When installing and during use of this
product, basic safety precautions should
always be followed to reduce the risk
of fire, electric shock and/or injury to
persons including the following:
• Make sure the installation area is free of
clutter.
• Do not place the product on an unstable
cart, stand, tripod or table.
• To avoid damage to the mirror, only
transport it in a vertical position.
Transporting the product horizontally
may permanently warp the mirror.
• Inspect the desired location for
installation and be aware of all electrical
wiring pathways, water pipes, gas
lines, or other potentially hazardous
conditions that may exist to protect
from accidental damage.
• Ensure all required electrical
specifications are adhered to and
have been installed by the appropriate
individuals and are code approved.
• Ensure all framing requirements, if
needed, have been completed to building
code and pose no structural issues.
• It is highly recommended that at least
two (2) people assist in the installation
of the mirror.
• Only qualified individuals should attempt
to service the product.
• Close adult supervision is necessary
when any product is used by or near
children.
• Protect against electric shocks and
burns by wearing safety gloves.
• Do not operate any product with a
damaged cord or plug or operate it after
the appliance malfunctions or has been
damaged in any manner.
• Do not let the power cord or wiring come
in contact with hot surfaces such as
radiators, heat registers, stoves, or other
products that produce heat.
• To protect against electric shock, do not
immerse the power cord, power plug, or
product in water or other liquid.
• This product is only intended for use
indoors.
• This product is not waterproof. Do not
immerse this product in water or expose
to dripping or splashing water as this
could cause an electrical hazard.
• In damp locations, it is REQUIRED that
the plug-in version of this product
is plugged into an electrical outlet
protected by a Ground Fault Circuit
Interrupter (GFCI) to protect against
electric shock, fire, and/or injury. Failure
to do so will void any warranty for this
product.
• The product must have proper, correct
and sufficient AC supply voltage.
• Retain this manual in a safe place for
future reference.
WARNING: READ ALL INSTRUCTIONS AND REVIEW THE COMPLETE DRAWING
PACKAGE BEFORE ATTEMPTING TO INSTALL OR SERVICE THIS PRODUCT.
WARNING:
Cancer and Reproductive Harm: www.p65warnings.ca.gov.
