Installation
Mounting
1. Shut off all power to the enclosure
prior to installing.
2. Remove the Sure-Set mounting
bracket from the main housing.
3. Using the two screws (included), at-
tach the mounting bracket to the
back of the electrical enclosure. (A
piece of double side tape is included
in the hardware kit to assist holding
the mounting bracket while attach-
ing the screws.
4. Snap the SSC into place on the
mounting bracket.
Fig. 3 Model SSC Typical Wiring
Wiring
1. Disconnect power to the conductor
cable from the power source prior to
proceeding.
2. Snap the split core around the power
conductor cable, and close the hous-
ing until the latch snaps shut.
3. Wire SSC output terminals to the
control box Digital Input (DI) ter-
minal (30 V max. terminal voltage).
Note: the output switch contacts are solid
state, and they work just like dry contacts.
When the output switch is closed, less than
1 ohm is present; when the output switch is
open, more than 1 ohm is present.
4. Close the enclosure and reconnect
power to the power conductor cable.
(For wiring example, see Figure 3.)
