![SetPower RV45S User Manual Download Page 5](http://html1.mh-extra.com/html/setpower/rv45s/rv45s_user-manual_1247341005.webp)
Installation
Please check whether the parts of Fridge/Freezer are complete after unpacking.
Note:
Place the unit in a dry place which is protected against splashing water. Do not place directly adjacent to
sources of heat (heating, gas ovens, hot water, pipes or under the blazing sun).
The normal operation of the appliance requires heat to be radiated away from the condenser located at the
end of the cabinet. Adequate air
fl
ow is required around the compressor at all times. (Fig. 1).
The cooling system has been designed to operate correctly when the appliance is positioned on angles up
to 30 degrees. It is recommended that the time the of unit is exposed to angles over 30 degrees is limited
to a maximum of four (4) hours continuous operation. (Fig. 2).
Application and Operative Cooling Range
The Fridge/Freezer is designed to operate on AC or DC voltage.
● Connect with 110-120V via AC adapter
● DC input 12V or 24V DC (e.g. car cigarette lighter or car battery)
● If the Fridge/Freeze is operating when the vehicle ignition switched OFF, the Fridge/Freezer
will switch OFF automatically when the power source voltage falls below the Battery Monitor
cut-out setting.
● The Fridge/Freezer will automatically switch back ON when the vehicle is re-started and the
power source voltage reaches the Battery Monitor cut-in setting.
Fig. 1
Fig. 2
30
°
Power Requirements
The cooling compartment has varying temperature zones. The values indicated on the digital display are
related to the middle of the cabinet. The Single Zone Fridge/Freezer is designed to either refrigerate or
freeze food. The Fridge/Freezer may be used for outdoor, use such as for camping purposes.The Fridge/Freezer
is designed to operate in ambient temperatures from -18°C to +10°C(0°F
to 50°F) in a maximum air humidity
of 90%. The Fridge/Freezer can operate continuously at an angle of 30° maximum.
4.
GETTING STARTED
03