- 4 -
English
- GB.4-V1 -
OPERATION & USE
Κ
BATTERY TEST
1.
Before you test a battery in a vehicle, turn off the ignition,
all accessories and loads. Close all the vehicle doors
and the trunk lid.
2.
Make sure you have put 6 pcs 1.5V batteries into the
battery chamber. Oxyride batteries are not
recommended because of the initial 1.7 Volt output. If
the 1.5V battery runs out of power, screen will show
“POWER LOW”. Replace those 6 pcs 1.5V batteries
before starting the test.
Note that nothing will be seen on the display until
the tester is connected to a vehicle battery.
3.
Make sure the battery terminals are clean. Wire brush
them if necessary. Clamp the black load lead to the
vehicle negative battery terminal. Clamp the red load
lead to the vehicle positive battery terminal. Please
clamp on the lead part of the terminal only. Clamping on
the iron part of the terminal will lead to wrong test
results.
