Servomex xendos 1800 Series, Quick Start Manual

Page: 12 / 27

xendos 1800 Series
5
2.4 Electrical installation
CAUTION
Connections to TB-4, analogue output signal/s terminals should not
exceed 30 V RMS (42.4 V peak) or 60 V dc to earth when connected
to associated equipment.
1
Electrical terminations are suitable for 20 AWG (0.5 mm
2
) to 14 AWG
(2.5 mm
2
) solid conductors or stranded conductors.
2
Gland entry sizes and positions are shown in Figure (A). Two of the three
cable entries are fitted with appropriate blanking plugs.
WARNINGS

The installer must be satisfied that the xendos 1800
installation conforms to the relevant safety requirements,
National Electrical Code and any other local regulations, and
that the installation is safe for any extremes of conditions
which may be experienced in the operating environment of
the analyser.

This appliance must be connected to a protective earth.

The electrical installation must include a means of isolating
electrical power by a switch or circuit breaker external to the
analyser and within easy reach of the operator. It must be
marked as the disconnecting device for the equipment.

It is essential that only suitably trained and competent
personnel are allowed to access hazardous live parts by
removing or opening covers of the analyser.

To comply with the European Community EMC Directives for
industrial environments the interconnecting cables used for
the mains supply, relay contact outputs and/or analogue
output signals should be screened or provide equivalent
protection.