Installing the Power Input Retention Bracket
For units with a total maximum output <30A, it may be necessary to install
the power input retention bracket prior to mounting the unit within the
rack.
To install the power input retention bracket:
1.
Remove the two screws attaching the IEC 60320 C19 inlet to the
enclosure.
2.
Assemble and attach the retention bracket to the enclosure as shown.
Figure 2.1 Retention Bracket Assembly
Mounting
Figure 2.2 Mounting
Horizontal/Rack
1.
Select the appropriate bracket mounting points for proper mounting depth within the rack.
2.
Attach the brackets to these mounting points with two screws for each bracket.
3.
Install the enclosure into your rack, using the slots in each bracket. The slots allow about ¼ inch of horizontal
adaptability to align with the mounting holes of your rack.
Vertical
1.
Attach the removable flanges to the mount points on the rear of the enclosure using M4 screws.
OR
2.
Attach the mounting L-brackets to these mounting points with two screws for each bracket.
3.
Attach the top and bottom brackets to your rack.
NOTE: Contact your Server Technology Sales Representative for information regarding custom bracket design and fabrication services if you are
unable to find a suitable manner for utilizing the included mounting brackets.
NOTE: Contact your Server Technology Sales Representative for information regarding optional button mounts for mounting the CDU into
supporting cabinets.
Basic Cabinet Distribution Unit
Installation
7
Installation Manual
