Read this first!
- This is a highly technical hobby product,
intended to be used in a safe racing environment.
This car is capable of speeds in excess of 80
km/h or 50mph. Please follow these guidelines
when building and operating this model.
- Parental guidance is required when the
builder/user of this car is under 16.
- Follow the building instructions. If in doubt,
contact your dealer or importer.
- Be sure to use the proper tools when
assembling the car. Always exercise caution
when using electric tools, knives and other
sharp objects.
- Be careful when using liquids like lubrication
oil, fuel or glue. Do not swallow.
- Follow the manufacturer’s instruction in case
you experience irritation after using the product.
- Be careful when operating the car. Stay away
from any rotating parts such as wheels, gears
and transmission. Stay away from motor, engine
and exhaust pipe system or speedo during and
immediately after use, as these parts may be
very hot. We advise to use protective hand
cloves.
- Only operate this car in a safe environment,
like a special racing track or a closed parking lot.
Avoid using this car on public roads, crowded
places or near infants.
- Before operating this car, always check
the mechanical status of the car. Also
check that the transmitter and receiver
frequencies correspond and are not used
by any other racer at the same time.
Check that the batteries of the transmitter
and receiver are fully charged.
- After use, always check all the mechanics
of the car. We advise to clean the car
immediately after use, and inspect the
parts for wear or fractures. Replace when
necessary. Do not use water, methanol,
thinner or other solvents to clean the car.
- Empty the fuel tank (depending on
model) if needed and disconnect the
receiver battery.
- Store the car in a dry and heated place
to avoid corrosion of metal parts.
- Avoid using this car in wet conditions as
the water will cause corrosion on the metal
parts and bearings and these parts will
cease to function properly. If driven in the
wet, ensure that all the electric equipment
is waterproofed and after use, that all
moving parts are dried immediately.
Length after assembly
Each step contains a variety of numbers, lines, and symbols. The numbers represent the
order in which the parts should be assembled. The lines and symbols are described below.
Assembly path of one item into another
Group of items (within lines) should be assembled
first
Direction the item should be moved
Glue one item to another
Press/Insert one item into another
Connect one item to another
Gap between two items
Step number; the order in which you should
assemble the indicated parts
USING THE MANUAL
1
Apply silicone grease (Orange),
Apply graphite grease (Grey),
Apply threadlock (Blue),
Apply silicone oil,