Note:
- In the program process, the motor will emit ‘Beep’ tone at the same time when the LED is flashing.
- If the ‘N’ is bigger than the number ‘5’, we use a long time flash and long ‘Beep---’ tone to represent ‘5’,
so it is easy to identify the items of the big number.
For example, if the LED flashes as the following:
‘A long time flash + a short time flash’ (Motor sounds ‘Beep---Beep’) = the No. 6 item
‘A long time flash + 2 short time flash’ (Motor sounds ‘Beep---BeepBeep’) = the No. 7 item
‘A long time flash + 3 short time flash’ (Motor sounds ‘Beep---BeepBeepBeep’) = the No. 8 item
And so on.
12
2.5. Maximum Brake Force:
The ESC provides proportional
brake function. The brake force is related to the position
of the throttle stick. Maximum brake force refers to the
force when the throttle stick is located at the end point
of the backward zone. A very large brake force can
shorten the brake time, but it may damage the gears.
3. Program The ESC
With SET Button
Please check the instructions below.
Flow chart: Program the ESC with the SET key
4. Reset All Items To Default Values
At any time when the throttle is located in neutral
zone (except in the throttle calibration process or
ESC program mode), hold the ‘SET’ key for over
3 seconds, the red LED and green LED will flash at
the same time, which means each programmable
item has be reset to its default value.
PROGRAM THE ESC WITH SET BUTTON
The following is a flow chart sample for programming the ESC.
