21
CLI Command
Function
Command
Syntax
help [enter]
help
*
Show list of commands
eth [enter]
eth
Ethernet IP configuration
setmac [enter]
setmac
Set Ethernet MAC address
fdl sw [enter]
fdl
Update PCIe switch firmware
lsd [enter]
lsd
Show environmental info (temps, FANs, voltages) on US_PM-2425
NVMe JBOF
showfan [enter]
showfan
Show FAN speed info on PCIe switch board
buz [en] / [dis] / [on] / [off] [enter]
buz
Control the buzzer of PCIe switch board
ssdpwr [Slot No.] [on o r off] [enter]
ssdpwr
Control the power of each U.2 NVMe drive slot
ssd_reset [Slot No.] [enter]
ssd_reset
To reset each U.2 NVMe SSD
showslot [Slot No.] [enter]
showslot
Show link speed and link width info on specific U.2 NVMe drive slot
showport [-t] / [-b] [enter]
showport
*
Show link speed and link width info on all U.2 NVMe drive slots and ports
showtemp [enter]
Show internal temperature of PCIe switch
bind [Slot No.] [enter]
bind
Bind any/all ports into switch group
unbind [Slot No.] [enter]
Unbind any/all ports from switch group
showbind [Slot No.] [enter]
showbind
Show binding info
setmode [1] / [2] / [3] [enter]
setmode
Set configuration mode for PCIe switch board
showmode [enter]
showmode
showtemp
bind
*
Show configuration mode for each PCIe switch board
pos [enter]
pos
Show position information for PCIe switch board within
US_PM-2425 NVMe JBOF
ver [enter]
ver
Show controller firmware version on PCIe switch board
reset [enter]
reset
To reset the PCIe switch board
This section provides detailed information about PCI-ENC8G-24UM-2X2 NVMe JBOF
CLI functions.
*
t
gaining he information,
In addition to the above three commands
(No. 1: help, No. 11: showport,
and No. 13: showmode)
which need connecting to only one switch
controller board for getting the info, the rest thirteen commands require
connecting to
Both
switch controller boards for
firmware update, and configuration.
unbind
