03
04
INSTALL
click
RELEASE
PRESS
HANDLEBAR MOUNTING
HELMET MOUNTING
To adjust the horizontal beam, spin the headlight
left to right for your best side to side beam angle.
To adjust the vertical beam angle, loosen the
mounting and rotate the light up and down to
your best vertical beam angle, then tighten
the mounting.
UNIVERSAL BRACKET INSTRUCTIONS:
Open bracket by pulling thumb lever down, then unclip the
thumb lever from the cam hook to open. Adjust the rubber
strap length to fit bar by moving the strap up or down the
rungs located under the swivel light mount. Once the length
of strap is adjusted for best fit, install around handle bar or
seat post by inserting thumb lever into cam hook, then
rotate thumb lever upwards towards swivel mount to lock.
If light still moves on the bar open thumb lever and shorten
strap by moving the rubber strap up to the next rung.
THUMB
LEVER
RUBBER
HORIZONTAL
TENSION
SCREW
RELEASE
LEVER
RUNGS
HELMET BRACKET INSTRUCTIONS:
1. Remove hook and loop strap from one side of the helmet mount.
2. Put helmet mount in desired location on helmet (top center works best).
3. Insert strap through nearest air vent on top of helmet and loop around
inside of top of helmet to the next closest vent to the open strap hole on the
helmet mount.
4. Put hook and loop strap through open hole on helmet mount and pull snug
and attach hook and loop to itself.
