background image

www.PyleUSA.com

3

Fig.A

Fig.B

4“AA”Batteries(Not Included)

Fig.1

Fig.2

Fig.3

LITHIUM BATTERY CHARGING INSTRUCTION

DRONE POWER SWITCH INTRODUCTIONS

REMOTE CONTROL BATTERY INSTALLATION

1. Open the battery cover of drone.,Take out lithium battery of drone from battery  

     case.(Fig.1)

2. Plug the USB charger into the power supply, and connect charger cord socket  

     with lithium battery socket. When charging, the USB LED light is off ; when the     

     charger LED light turns red again , charging is complete. Charging time is    

     approximately 150 minutes.

3. Connect the battery plug with the circuit board plug after charging. Please pay  

     attention to the correct polarity. (Fig.3)

4. Close battery cover of drone.

Attention:

1. Make sure the USB Charger fits properly into the USB port that is being used for    

    charging. If the charger is not inserting easily into the port, do NOT forcefully  

    insert the charger, as it could cause damage to the charger or battery.

2. The charging plug will overheat if overcharged for long periods of time. Do not  

     leave the battery on the charger for longer than 3 hours as it may cause damage  

     to the battery.

3. Do not leave the battery inside the drone when charging.

4. Do not use any chargers other than the one supplied, as it could cause damage  

    to the battery.

5. Wait 15-20 minutes after flying the drone before recharging the battery, to    

    prevent the battery from overheating.

6. Do not leave the battery near any hot surfaces or in direct sunlight for long    

     periods of time, as this can cause serious damage to the battery.

7. Do not puncture or damage the battery. If the battery is damaged, stop using it  

    and contact the manufacturer.

To turn 

ON

 the drone, press the power button located 

on top of the drone. To turn 

OFF

 the drone, 

PRESS

 and 

HOLD

 the power button for 3 seconds.

1. Remove the battery cover from the back of controller (Fig. A)

2. Install 4 “AA” batteries into the controller, make sure to install batteries to their

    correct polarity. (Fig. B) Do not mix old and new batteries or battery types.

3. Replace the battery cover 

Reviews: