Figure 6
Figure 5
www.SereneLifeHome.com
8
•
Press the pressure unit switching button to switch
between the units, and press the power
on/off
button
to stop.
•
When the pressure reaches the set value, the air pump will stop
working automatically.
•
Upon the completion of inflation, it will turn off automatically
without other operations within 2 minutes.
•
After pulling out the DC plug, please take down the hose from
the air pump and air bag and store it.
•
Notice:
The factory set pressure value of the air pump is 10PSI
(10PSI=0.689BAR), and at the time of the secondary use, the set
pressure value for the last time use will be displayed by default.
•
Notice:
After powered on, if there is no operation within 2
minutes, the air pump will enter standby mode, and the
machine can be initiated by pressing the power switch button.
VIII. DEFLATION OPERATION
•
Remove the hose from the inflation inlet. Connect the end with
flexible conduit adaptor (6)
of the hose with the air pump
deflation outlet (7), and twist clockwise to tighten it, as Figure
3, and the other end shall still be to the airbag.
•
Press the button of the power switch of air pump, and start the
deflation until all the gas is discharged, then the power can be
turned off to stop the deflation.
www.SereneLifeHome.com
9
IX. PRECAUTIONS
•
As this product has a lithium battery, it can work using the
battery, or the plug of the product can be inserted into the
cigarette lighter socket on the car for use.
•
The applied power source must be the 12V DC power source (as
Figure 8).
•
Do not block the inflation inlet (1) and Deflation outlet (2), and
ensure that the inflation inlet (1) and Deflation outlet (2) shall
remain smooth at all times.
•
Observe the local waste treatment provisions, and it is not
allowed to throw the air pump away randomly.
•
Don't use this product when the hose is damaged, and please
change the hose immediately.
•
Don't pull out the hose when inflating, because that the high
pressure may hurt the physical body.
•
Don't make the air pump work for more than 30 minutes,
because that motor overheating may cause internal damage;
and the air pump shall be fully cooled for 30 minutes after
continuously working up to 30 minutes.
•
Please don't use this air pump if any part is damaged, and contact
with the professional personnel to repair it.
•
This product shall not be exposed to
the rain or immersed in water.
•
In order to prevent risk, the inflation
inlet shall not be forward to face or
body.
•
Please don't not leave while inflating.
Figure 7
Figure 8
