Fault Inspection Solution
The air
pump
cannot be
started
normally.
1. The power source
is not plugged
properly.
2. The fuse in DC
plug (7) is burnt out.
3. Overheating or
overload causes
motor stop.
1. Check whether
the hose is blocked
or cracked.
2. The joint between
the hose and air
pump or air bag is
not installed
properly.
1. Make sure that the power wire is
plugged in the 12V DC socket.
2. Change the fuse.
3. Cool the motor and restart it.
4. If the problem cannot be solved,
please contact with the manufactur-
er or its service agent or the similar
authorized personnel.
1. Change the hose or make it
unblocked, and check whether the
hose is cracked.
2. Reinstall the hose.
3. If the problem cannot be solved,
please contact with the manufactur-
er or its service agent or the similar
authorized personnel.
Slow or
abnormal
inflation.
(Figure 3)
• When the pressure reaches the set value, the air pump will
stop working automatically.
• After completing the inflation, pull out the DC plug from the
12V DC socket.
• After pulling out the DC plug, please take down the hose from
the air pump and air bag then store it in a safe place.
•
Notice:
The factory set pressure value of the air pump is 10PSI
(10PSI=0.689BAR), and at the time of the secondary use, the
set pressure value for the last time use will be displayed by
default.
•
Notice:
After powered on, if there is no operation within 2
minutes, the air pump will enter standby mode, and the
machine can be initiated by pressing the power switch button
VI. PRECAUTIONS
• The applied power source must be the 12V DC power source
(as Figure 3).
• Don't block the air inlet (10) at the bottom of the air pump,
and guarantee air inlet (10) to be always unblocked.
• Observe the local waste treatment provisions, and avoid
throwing the air pump away randomly.
• Don't use this product when hose is damaged and change the
hose immediately.
• Don't pull out the hose when inflating because high pressure
may hurt the physical body.
• Don't make the air pump work for more than 15 minutes,
because motor overheating may cause internal damage. The
air pump shall be fully cooled for 30 minutes after
continuously working up to 15 minutes.
• Please don't use this air pump if any part is damaged. Please
contact professional personnel for repairs.
• This product shall not be exposed to rain or immersed in water.
• In order to prevent risk, place the inflation inlet opposite to
face or body.
• Avoid leaving SLPUMP10 while inflating.
VII. FAULT HANDLING
VIII. MAINTENANCE AND STORAGE
• After using, or if you want to move, maintain or adjust the
product, please first pull out the DC plug from the socket.
• When it is idle, it shall be properly stored after fully cooled.
• It shall not be exposed to the rain or immersed in water.
• Please store in a dry and ventilated place.
IX. SUGGESTIONS
The warranty period of this product is one year, and it is
suggested to use the original accessories. For any fault not
caused by using the original accessories, it shall be out of the
warranty scope.
5
www.PyleUSA.com
4
www.PyleUSA.com
www.SereneLifeHome.com
www.SereneLifeHome.com
