Serene centralalert CA-CX, User Manual, Page: 16 / 21

-28-
Press “ ” key during recording, the message being recorded
will not be saved.
A long beep tone will be transmitted to indicate that ICM recording
is finished.
7. With only ten seconds remaining before memory is full, the machine
will announce “Please complete your call within ten seconds.” After
ten seconds, it will stop the ICM recording and releases the line.
The message will be saved as a new message.
8. If the memory is full, an incoming call will be picked up by the
machine,plays back the OGM followed with “Sorry, memory is full”
and then hangs up the line.
New message indication
If there are new messages, the new message LED will be flashing
and the 7 segment LED will indicate the number of messages.
A display of “2” means there are two new messages.
If there are new messages but with old messages, the new
message LED still will be flashing but the LED display shows the
total message count not just the number of new messages.
If message alert is on, the machine will beep every 30 seconds.
Message playback
1. Press “ ” key once to play messages.
* If there are new messages, it will announce “you have X new
messages, new message one (message content), new message
two (message content)”, until the X new message. After finishing
the playback, it announces “End of messages”.
5.
6.
1.
2.
3.
* If there are no new messages but there are old messages, it will
announce “You have no new messages. You have X messages,
message one (message content), message two (message content)”,
until the X message. After playback is finished, it announces “End
of messages”.
* If there are no any messages, it announces “You have no messages”.
2.Press “ ”key for one time will display the next one message;
press “ ” key for one time ,will display the last one message;
press “ ” key for one time , will stop displaying ;press “ ” for
one time return to standby mode;
Erase messages
During message playback, press “ ” key once to erase individual
message; it will announce “Message deleted”. The machine will
then play the next message but if all messages are deleted, it will
announce “End of messages”.
At standby mode, press and hold “ ” key for 3 seconds to erase
all messages, the machine will announce “All messages deleted”.
1.
2.
Time setup
This setting allows you to set the current day and time for Time/Day
stamp attached to each message. Messages' Time/Day stamp will
not be attached when it is not set up.
2. The LED display shows “PL” when Date and Time are not set up.
3. Time setup resets every time the power supply is unplugged.
4. If the date and time are not set, the machine will say “Please set
date and time” when the “ TIME ” key is pressed once.
Press and hold “TIME ” key for 3 seconds to enter date/time setup
mode:
The machine announces “Set year”. The LED display indicates
the year, for example “06”. Press “ ” or “ ” key to increase or
decrease respectively
the year setting and press “TIME ” key to
confirm;
1.
5.
6.
DELETE
DELETE
VOL VOL
-29-