2
If sensor needs to be factory defaulted (for example, to prepare it for joining with a home controller or security system).
1.
Remove sensor cover.
2.
Remove the CR2 battery from sensor.
3.
Depress the tamper switch before inserting the battery.
4.
Insert the battery. The sensor should illuminate the LED once when boot-up/initialization tasks are complete.
5.
Release the tamper switch while the LED is illuminated (it will be lit for 4 seconds). The sensor should then
reset to factory default settings and begin searching for any available home controller or security system. If you need to reboot the device,
remove the battery, depress and release the tamper switch one time, then re-insert the battery.
6.
Place the cover back on sensor.
Note:
Replace Battery with CR2 only. Use of another battery may negatively impact the performance of the product.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
The FCC ID for this device is P27SSH1R0
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement:
•
This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
•
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with a minimum distance of 20 centimeters between the radiator and your body.
Reset to Factory Defaults & Reboot
Certification