47
TA 504
Rev.
3
en 11/2021
Subject to technical modifications!
www.sera-web.com
EN
Electric agitator
MU-037300 E 187.2
MU-055450 E 114.2 / MU-075550 E 094.2
Operating instructions
6. Setup / Installation
■
The electric agitator is only approved for installation in dry areas in a non-aggressive atmosphere at temperatures
b2° and +40°C and an air humidity of up to approx. 90%.
■
No exposure to direct sunlight.
■
For the dimensions of the fixing holes of the protective flange, see chapter "Dimensions".
■
Check that the fixing screws are tightly fitted and retighten the nut, if necessary
(tightening torques see chapter "Assembly / Disassembly").
■
Install the electric agitator at the optimum possible operating height.
■
Maximum installation height is 2000m (reduction in performance above 1000m above sea level).
■
Minimun immersion depth (½ Agitator diameter)
The Electric agitators are not suitable for pass-through operation.
CAUTION!
7. Assembly / Disassembly
■
Prior to work, turn off the power and protect the system from being turned on again!
In case of contact with live components there is danger to life.
Switched on electrical components may cause uncontrolled movements
and lead to serious injuries!
DANGER!
■
Prior to work, ensure that there is sufficient space to perform the installation.
■
Be careful when handling sharp-edged components.
■
Make sure the work station is tidy and clean! Loose parts or parts and tools lying around may cause accidents.
■
Secure components so that they can not fall down or topple over.
An improper installation and initial start-up may lead to serious damage to per-
sons or property!
CAUTION!
Summary of Contents for MU-300 E 187.2
Page 58: ......
