SEPTENTRIO PolaRx5TR, Reference Manual

Page: 203 / 512

3 Command Line Reference
3.2.14 WiFi Settings
eawa
gawa
exeAddWiFiAccessPoint
getAddWiFiAccessPoint
SSID (32) Key (40)
RxControl: Communication > WiFi Settings > Client Add Network
Use this command to add a WiFi access point to the list of known access points, or to modify
the password of a known access point. The
SSID
argument is the identifier of the access point
and the
Key
argument is the password needed to connect to the access point.
This command must be entered for all access points that the receiver is to connect to. For
open access points that do not require a key, set
Key
to "".
When the receiver is configured in WiFi client mode with the
setWiFiMode
command, it will
check if a known access point is reachable and automatically connect to it.
By default, if multiple WiFi access points are reachable, the last one that was
added with the
exeAddWiFiAccessPoint
command has the priority. Use the
exeManageWiFiAccessPoint
to overrule this and manually define the preferred access
point.
The command permanently adds the WiFi access point to the list of known networks. The
list is persistent across power cycles. The
exeManageWiFiAccessPoint
command can
be used to remove an access point from the list (i.e. to forget an access point), and the
exeResetReceiver, hard, WiFiAccessPoints
command can be used to erase the
complete list.
Use the command
lstWiFiAccessPoints
to get a list of the known and/or reachable WiFi
access points.
Example
COM1> eawa, MyWiFi, 12345678<CR>
$R: eawa, MyWiFi, 12345678
AddWiFiAccessPoint, MyWiFi, "7VBC0NULTV6I"
COM1>
203