CHAPTER 5. CONF
I
GUR
I
NG THE ASTERX SB SX AS A ROVER
4.
I
f the con
fi
guration is correct, the graphic should show a green line to the NTR
I
P Caster,
indicating a successful connection with the NTR
I
P Caster, as in Figure 5-5, with details
of the correction stream.
Figure 5-5:
Receiving di
ff
erential corrections via NTR
I
P
I
f the NTR
I
P Mode Field is set to
Client
and the con
fi
guration saved to boot, the AsteRx SB
Sx will auto-connect to the NTR
I
P Caster each time it is powered.
I
f the Mode Field is set to
Off
, no corrections will be received and the AsteRx SB Sx
will not auto-connect to the Caster when switched on.
Step 3b: Configure corrections using an IP connection
Configure the IP connection of the Rover receiver
Alternatively, corrections can also be received using an
I
P connection in which case no
internet connection is required but an
I
P connection to a Base station is necessary.
On the
IP Ports
window of the Rover receiver, click on
New IP Receive Connection
as shown in Figure 5-6 to start the connection con
fi
guration sequence. The
Port
and
TCP
Address
should match the port and
I
P address of the Base station receiver.
27
Summary of Contents for AsteRx SB Sx
Page 1: ...AsteRx SB Sx User Manual ...
