CHAPTER 4. CONFIGURING THE ALTUS NR3 AS A ROVER
4.2.2 Connection to an NTRIP Caster
Step 1: Configure the NTRIP Client settings
1. Make sure you have a cellular connection as described in the previous section.
2. On the
Corrections/NTRIP
window, click on
New NTRIP client
as shown in Figure 4-4
Figure 4-4:
NTRIP tab of the Web Interface
3. Enter the NTRIP caster details as shown in Figure 4-5 and click
Ok
. The mount point list
will only be populated when the caster details have been entered correctly.
Figure 4-5:
NTRIP Settings
4. Click
Ok
to apply the
fi
nal setting. If the con
fi
guration is correct, the graphic should
show a green line to the NTRIP caster as in Figure 4-6, with details of the correction
stream.
29
Summary of Contents for ALTUS NR3
Page 1: ...Altus NR3 User Manual ...
