Monitor Camera and DVR Connections
Use the following image and steps to connect the monitor and camera to the DVR power.
1
Once the camera is installed, connect cable A to cable B.
2
Connect cable B to a camera socket on the back panel of the TL-HD DVR.
3
Connect the 8x1 Sherlock connector on cable C to the EXPANSION socket on the TL-HD DVR.
4
Connect the 2x3 Microfit connector on cable C to the micro fit socket on cable D.
5
Connect the 2x3 Microfit connector on cable D to the brown micro fit socket on cable E.
6
Install the monitor bracket and monitor on the dashboard, using the hardware and installation guide provided in the monitor kit.
7
Connect the monitor output to cable E.
8
Connect the brown wire from cable E to the striped end of the supplied diode.
9
Connect the unmarked end of the supplied diode to the reverse signal input.
10 Cut off the 1x2 Microfit connector on cable B and use the crimp to connect the black wire from cable B to the black wire on cable E.
11 Cut the fuse from the red wire on cable E.
12 Use the crimp to connect the red wire from cable E to the red wire from cable B.
13 See “Power On and Test”.
Rear Vision System With TL-HD DVR
TL-HD
DVR
Rear
Panel
2
3
7
8
4 wires
+ 12V
(red)
Negative
(black)
POWER
9
10
Not Used
(yellow)
Cable Legend
A
1
D
E
LCD
Monitor
Brown
Connector
Yellow
Connector
(Not Used)
4
B
Black wire
Red wire
12
C
A - Camera extension cable HE2 (50`) or HE3 (75`)
B - Camera power cable 060-1010
C - Expansion cable 060-1014
D - Extension cable HE1
E - Monitor power and connector cable 060-0676
5
6
11
CA or RVC303
Rear View
Camera,
Installed
Reverse Signal
(brown)
Power On and Test
1
Turn on accessory power to the vehicle.
2
Set the vehicle to reverse.
In normal operation, the monitor will only turn on when the
bus is put into reverse.
If the monitor fails to turn on when power is applied, confirm
power connections. Disconnect and firmly reconnect the LCD
Monitor cables.
3
Configure the DVR. See “DVR Configuration”.
4
Adjust the camera view so that the bumper of the bus is just
visible across the bottom edge of the monitor.
5
Refer to the camera installation guide for details on closing
and fastening the camera once it has been aimed.
6
Configure the monitor to power on when the reverse signal is
triggered. See “LCD Monitor Configuration”.
7
Turn off accessory power to the vehicle.
DVR Configuration
When the reverse signal is on, the camera view displays in the
RVS monitor. Otherwise, the monitor will be OFF (dark).
NOTE
: HD camera views cannot be displayed on the monitor.
When the RVS is integrated with a TL-HD DVR, the image
displayed on the RVS Monitor comes from the DVR and will
display information according to the DVR settings.
Use the following steps to configure the DVR to properly display
the RVS camera information.
1
On the DVR, plug in a diagnostic monitor into the front Video
Out RCA jack and plug in a USB mouse.
2
From the camera views that display, identify the RVS camera
feed and the camera view title for use in the configuration
menus.
3
Right-click and select Configuration, then select Title/Display.
LCD Monitor
MX-HD ONLY
USB Mouse