Installation
700-0048 R003
2–5
2.3. Step 2: Installing the DVR in the Lock Box
The DVR has two brackets attached to the sides that allow it to slide easily in and
out of the lock box. The brackets also enable easy top-up orientation of the DVR
when the unit is installed on the floor or under a seat.
The rear of each bracket has two plastic retainers that allow cables to easily slip in
between to ensure they do not get pinched at the back of the lock box when the
DVR slides in.
2.4. Step 3: Installing the Cameras
If you have purchased cameras from Seon Design, install the cameras according
to the documentation that shipped with the product.
If you have cameras already installed, see “2.4.1. Checking the Camera Cable
Connections”.
2.4.1. Checking the Camera Cable Connections
The EX8 Plus System uses an integrated mini-DIN connector for all of the camera
signals. The cable comes prewired into the camera, but in the event that the cable
becomes disconnected, reattach into the terminal blocks inside the camera. See
Figure 2-3. The cable colors for correct wiring to the terminals are described in
Table 2-1. For complete camera information, see the product insert for the camera
(for example,
SA Series Wedge Camera Setup Guide
document part number 700-
0004
).
Figure 2-2
Lock box vertical installation
Vertical mounting
screw
