Installation
2–4
700-0048 R003
6. Slide the lid on to the lock box and secure it with the two retaining screws.
2.2.2. Vertical Installation
For installation in a difficult location, the lock box can be mounted vertically.
To install the lock box vertically:
1. Unlock the door with the key provided and remove it from the base of the lock
box.
2. Slide the DVR out of the lock box by pulling on the two bracket tabs at the
front of the DVR.
3. Detach the lid from the lock box by removing the two retaining screws on
either side of the lid near the front of the lock box.
4. Determine whether the power and camera cables will enter the lock box on
the left or the right side. Swap the cable grommet and the hole plug, if
necessary.
5. Use 3 of the enclosed #10 × ¾ sheet metal screws or #10 × 1 self-drilling
screws to attach the lock box to the floor. See Figure 2-2.
6. To prevent excess vibration, use the remaining #10 × ¾ sheet metal screw or
#10 × 1 self-drilling screw to secure the lock box to a vertical surface.
7. Reattach the lock box lid using the two screws removed earlier.
Figure 2-1
Lock box horizontal installation
Cable grommet
Hole plug
Important:
It is highly recommended that the Vertical Mounting Bracket Kit is used to
help stabilize the lock box in a vertical installation. If you are mounting the lock box
vertically, please contact your Seon Design sales representative or dealer for information
on the Vertical Mounting Bracket Kit before starting
the installation.
