v 1.0 150219
SEO CANi IMMOBILIZER – USER MANUAL
1. Disarming/arming SEO CANi immobilizer
Disarming
– while the ignition is ON, press the previously set
buttons’ combination
. Single blink of the dashboard
indicator
will confirm
disarming of the immobilizer. The time between pressing consecutive buttons must be shorter
than 5 sec; in some vehicles this time must be longer than 0.4 sec.
Arming
– automatic after switching the ignition OFF and opening the driver’s door (2 blinks of the dashboard
indicator)
2. Service mode
To switch the
service mode
ON using only the PIN code, turn the ignition ON, disarm the immobilizer by entering
the previously set PIN code and holding the last programmed button for 10 seconds. If you successfully managed to
enable the
service mode
, the indicator on the dashboard will blink 5 times.
If you want to switch the
service mode
OFF, just enter the PIN code holding the last button until the dashboard
indicator blinks once.
WARNING – in the
service mode
the dashboard indicator does not indicate that the
service mode
is active and
the car is not protected – the car owner, after picking the vehicle up from servicing, should immediately switch
the
service mode
OFF. During normal operation, the SEO CANi immobilizer indicates (by the dashboard
indicator light) whether it has been armed or disarmed.
3. Changing the PIN code (changing the combination of buttons to disarm the
vehicle)
Enter the previous PIN code to disarm the immobilizer. Then, follow the steps for setting the PIN code.
4. Setting the PIN code (setting the buttons combination)
The PIN code
is a combination of any buttons available in a particular vehicle (supported buttons are listed on the
connection diagram for the respective vehicle).
Procedure 1
: While the ignition is ON, disarm the immobilizer by entering your PIN code and press the acceleration
(gas) pedal 10 times (if the pedal is supported in a particular vehicle). Two blinks of the dashboard indicator will
indicate entering into the programming mode. Press the combination of 1 to 15 supported buttons. Just after entering
the combination, turn the car ignition OFF to save the new PIN code. If you do not switch the ignition OFF within 10
seconds, the new PIN code will be discarded. The indicator used to show the immobilizer’s status can be found on
the list of supported vehicles.
Procedure 2:
With the ignition ON, enter the 11999 program number using the switch placed on the PCB – further
steps are the same as in Procedure 1.
