2.
Slide the
Power
switch on the power paddle to the
ON
position. The
green
POWER
light will illuminate.
Note
: If the green
POWER
light does not illuminate, you may need to
replace the 9 volt battery inside the power paddle. The battery
compartment is located on the back of the power paddle.
3.
Once the power paddle is turned on, the red
Status A
light will illuminate for approximately one
minute. During this time, the power paddle is charging the lockbox.
4.
When the power paddle finishes charging the lockbox, the yellow
Status B
light will illuminate.
5.
Once the yellow
Status B
light has illuminated, insert your
SentriCard® into the card slot on the left side of the power
paddle. The SentriCard® must be inserted face up with the
gold chip going in first.
The steps to use the power paddle at an NXT series lockbox and an NXT Wireless series lockbox are
different. Please follow the steps according to which lockbox you are using the power paddle on. To
determine what type of NXT lockbox you are using the power paddle on, refer to the front, left side of
the lockbox. If you find a
Wireless
sticker here, you are using an NXT Wireless lockbox. If the sticker is
not there, you are not using an NXT Wireless lockbox.
NXT Lockbox:
6.
The lockbox will illuminate the
CARD
and
CODE
lights.
7.
Wait for the green
Status C
light to illuminate on the power paddle.
8.
Enter your
PIN + ENT
on the lockbox keypad.
9.
The lockbox will display the green
READY
light.
10.
Press
FUNC + 3 + ENT
on the lockbox keypad.
11.
The lockbox will open the key compartment, allowing access to the battery compartment.
12.
After the key compartment opens, remove the power paddle from the lockbox.
13.
Slide the
POWER
switch on the power paddle to the
OFF
position.
