Sentera RSCOH-R, Mounting And Operating Instructions

Page: 10 / 10

www.sentera.eu
MIW-RSCOH-R-EN-000 - 25 / 03 / 2020 10 - 10
back to the table of contents
NOTE Green LED intensity can be adjusted between 0 and 100 % with step of 10 %
according to the value set in Holding register 80.
Ambient light sensor
The measured light intensity in lux is available in Input Register 41. Additionally,
an active and standby level can be defined in Holding registers 35 and 36. Input
Register 42 indicates if the measured value is below standby level, above active
level or in between both levels:
■
Ambient light level < standby level: Input Register 42 indicates “Standby”.
■
Ambient light level > active level: Input Register 42 indicates “Active”.
■
Standby level < Ambient light level < Active level: Input Register 42 indicates “Low
intensity”.
VERIFICATION OF INSTALLATION INSTRUCTIONS
After switching on the power supply one of the LEDs lights up according to the
status of the measured variable. If this is not the case, check the connections.
TRANSPORT AND STORAGE
Avoid shocks and extreme conditions; stock in original packing.
WARRANTY AND RESTRICTIONS
Two years from the delivery date against defects in manufacturing. Any modifications
or alterations to the product after the date of publication relieve the manufacturer
of any responsibilities. The manufacturer bears no responsibility for any misprints or
mistakes in this data.
MAINTENANCE
In normal conditions this product is maintenance-free. If soiled, clean with a dry or
damp cloth. In case of heavy pollution, clean with a non-aggressive product. In these
circumstances the unit should be disconnected from the supply. Pay attention that
no fluids enter the unit. Only reconnect it to the supply when it is completely dry.
RSCOH-R
MULTIFUNCTIONAL
ROOM TRANSMITTER