www.sentera.eu
MIW-RSTHM-2-EN-000 - 15 / 01 / 2019
5 - 10
back to the table of contents
STANDARDS
■
Low Voltage Directive 2014/35/EC; EN 60529:1991; EN 60730-1:2011
■
EMC Directive 2014/30/EC; EN 60730-1:2011, EN 61000-6-1:2007, EN 61000-6-
3:2007, EN 61326-1:2013, EN 61326-2-3:2013
■
WEEE 2012/19/EC
■
RoHs Directive 2011/65/EC
OPERATIONAL DIAGRAMS
10
20
30
40
50
60
70
80
90
100
Minimum
range
Minimum
alert
Maximum
alert
Input register 1
or 2 [%]
T [°C] / rH [%]
*
Maximum
range
Out of
range
Within
range
Alert range
Alert range
Out of
range
*
LED indications refer to T (default) or rH, depending on the selected parameter
MOUNTING & OPERATING INSTRUCTIONS IN STEPS
Before you start mounting the RSTHM-2 room transmitter, read carefully
“Safety
and Precautions”
. Choose a smooth surface for installation (a wall, panel and etc.).
Follow these steps:
1.
Using a flat screwdriver, remove the front white cover by releasing the snap-fits
on its both sides (see
Fig. 1
Snap-fits release
).
2.
Insert the crimped RJ45 cable through the opening on the rear plate and plug it
into the socket (see
Fig. 2
Mounting dimensions
).
3.
Using suitable fastening materials (not supplied), position the room sensor at
least 1,5 m from the floor. When planning the installation, allow enough clearance
for maintenance and service. Mount the sensor in a well-ventilated area. Mind
the correct mounting position and unit dimensions. See
Fig. 2
and
Fig. 3
.
RSTHM-2
COMBINED T AND RH
ROOM TRANSMITTER