Sensors & Software PDP1000, User Manual

Page: 21 / 104

PDP User's Guide Getting Started
9
To minimize interference and ensure consistency of measurements, it is important
that cables are secured to the cart frame, and not left dangling. Dangling wires will
interfere with the quality of data collected by the PDP.
For the GPS cable, connect it to the PDP sensor and make sure the cable is tight
and fastened to the fibreglass frame as you route it upwards towards the GPS
receiver (Figure 2-12). If there is any excess cable, secure it near the GPS using
the Velcro straps provided. Finally, connect the GPS cable into the GPS receiver
(Figure 2-13).
Figure 2-12: Make sure the GPS cable is routed as shown and secured to the cart,
as it moves from the PDP sensor up to the GPS receiver along the cart frame.